Sears 172.10855 warranty Unpacking, Assembly

UNPACKING cont.

PARTS LIST (Fig. 1)

3.Blade Wrench

(for changing the blade)

4.Operator's Manual

®

12

Amps

7 1

1.Saw

2.Blade (unassembled)

ASSEMBLY cont.

INSTALLING THE BLADE cont. (Figs. 2 and 2a)

! WARNING: BE SURE to wear protective work gloves while handling a saw

blade. The blade can injure unprotected hands.

! WARNING: A 7 1/4-inch blade is the maximum blade capacity of your saw.

A larger than 71/4-inch blade will come in contact with the blade guards. Also,

NEVER use a blade that is so thick that it prevents the outer blade washer from

engaging with the flat side of the spindle. Blades that are too large or too thick

ASSEMBLY

INSTALLING THE BLADE (Figs. 2 and 2a)

Carefully remove the blade from its packing, inspect it to be sure that it is not cracked or damaged.

1.Saw should not be plugged into power source.

!WARNING: To prevent personal injury, ALWAYS disconnect the plug from power source BEFORE assembling parts, making adjustments or installing blades.

2.Place saw on its side on a flat surface.

3.To loosen the depth-of-cut adjustment lever, raise the saw up all the way and tighten lever. This gives you easier access to blade mounting area (see Fig. 2a).

4.Place saw upright, on its base and on a flat surface (see Fig. 2a).

5.To loosen the spindle clamping screw “A”, depress the spindle lock button (see Fig. 2). Place the blade wrench on the spindle clamping screw “A”. Move the wrench back and forth until you feel the spindle lock button depress further and it locks the blade in position so the spindle clamping screw can be removed. Keeping the spindle lock button firmly depressed, turn the spindle screw counterclockwise to remove.

	Spindle
	Lock Button
	Tighten
	Depth-of-Cut
®	Adjustment Lever
	Loosen
	Fig. 2

Fig. 2a Outer “D” Washer

“A” Spindle

Clamping Screw

Blade Rotation

teeth point up at front

12

can result in an accident causing serious injury.

6. Completely remove the spindle clamping screw “A” and the outer “D” washer

(see Fig. 2a).

7. The remaining washer is the inner bushing washer that fits around the spindle shaft

and it does not need to be removed.

8. Put a drop of oil onto the inner bushing washer and outer “D” washer where they will

touch the blade.

9. Raise lower blade guard using the blade guard lever and hold it in the raised position

for the next step.

10. Place the saw blade inside the lower blade guard, onto the spindle shaft and against

the inner bushing.

NOTE: The teeth of the blade should point upward at the front of the saw as shown in (Fig. 2a).

11.Replace the “D” washer.

12.Firmly hold down spindle lock button as you replace the spindle screw and hand tighten it in a clockwise direction. Then use blade wrench to tighten the spindle clamping screw thoroughly.

NOTE: NEVER use a blade that is too thick to allow the “D” washer to engage with the flat side of the spindle.

REMOVING THE BLADE (Figs. 2 and 2a)

1.Unplug the saw.

2.Follow steps 2. through 6. of “INSTALLING THE BLADE” and remove the blade (see Fig. 2a).

13

REV 10855

2-12-08