Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels
The channels available in your area must be programmed into the TV's memory when you hook up your TV. Using CHANNEL up and down allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add or Delete Channels section below.
lo Place channels in | 13! |
memory (Autoprogram) |
|
;ontrols | Alarm Ad |
3ntrols Alarm Adjust Setup
A. Hook up an antenna, cable or components before you begin
these steps or you will not be able to add channels into
memory.
B. Press MENU.PROG repeatedly
to select the Setup Menu. This menu is white.
C. Press MOVE • to highlight Autoprogram.
D. Press MOVE • to start the TV adding all active channels into memory.
E. Wait until the TV has cycled through all the channels and returns to the original channel.
2. Add or delete channels
Controls Alarm Ad
Controls Alarm Ad
a. Press MENU,PROG repeatedly
to select the Setup menu. This menu is white.
B. Press MOVE • to highlight Channel Memory.
C. Press MOVE • to underline the channel number.
D.Select the channel number you want to add or delete with the number buttons.
E.Press MOVE • to add or delete
a channel (you will see Stored on the screen when added and
Erased when deleted).
F° Repeat D and E for more channels.
2O
