![](/images/new-backgrounds/1010565/1056579x1.webp)
SECTION5. CAREFORTHE MACHINE
•Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area
about every three months.
Center pin of |
|
|
the shuttle | Shuttle | driver |
| ||
|
| Lever |
| Lever | hurtle |
| Lever |
|
case
To Clean the Shuttle Area:
1.Raise the needle bar to its highest point and remove the bobbin case.
2.Push shuttle race levers aside. Lift shuttle race cover and take shuttle out.
3.Clean the shuttle race with a llnt brush.
To Replace Shuttle Assembly:
1.Position shuttle race as illustrated so that shuttle driver is forming half moon on the left side of the machine.
2.Hold shuttle by center pin and position shuttle so as to form a half moon on the right side. Pointed hook will be on the bottom.
4.Put a drop of oil on the center pin of 3. Place shuttle race cover into place over shuttle
the shuttle and shuttle race. Do not |
| assembly. |
| 4. | Snap the levers back into the original position. |
|
39