Sears 385. 12714, 385. 12712 Set Up Machine Free-Arm Sewing the Removable, Extension Table

			SECTION 2.
Set Up the	Machine (Continued)
• Free-Arm	Sewing: the Removable	• Accessory Storage Box	• Change the Presser Foot
Extension Table

Q

\!

PREPARE THE MACHINE FOR SEWING

Choose the Needle and Thread

•To Change the Needle

(

_",_"k Needle clamp screw

•-._ /

,_i

Flat side

away from

you

To	Remove	the Extension Table	The	lid	of the accessory storage
(for	free-arm	sewing)	box	lifts	open toward you.

1. Grip the table with your index finger Sewing accessories are conveni-

and thumb, as shown,

ently located in the box.

2.Pull gently to the left. The extension table will snap out.

To Attach the Extension Table

(for flat*bed sewing)

1.Insert the tab and the pin into their catches.

2.With your thumb and index finger, gently snap in.

Use the correct presser foot for

the stitch you wish to sew.

To change the various presser feet, raise the presser bar to its highest position by lifting the presser foot lever.

Loosen the presser foot thumb screw, choose the proper foot, insert from the bottom.

Tighten the screw using the large screw driver to make certain the foot is secure.

NOTE: Raise the needle bar to its highest position by turning the hand wheel toward you.

I, Loosen the needle clamp screw by turning it toward you.

2, Remove the needle by pulling it down- ward.

3. Insert the new needle into the needle clamp with the flat side away from you.

4.Push the needle up as far as it will go.

5.Tighten the needle clamp screw firmly

with the rarge screwdriver from the accessory box.