STEP 3: (SEE FIGURE 3)
•Tighten all hex nuts and bolts, following the same sequence as assembled in steps 4, 5 and 6. Do not collapse tube when tightening.
•Assemble a spacer and then a 1/2" flat washer onto each end of the axle.
AXLE
SPACER
1/2" DIA.
FLAT WASHER
FIGURE 3
STEP 5: (SEE FIGURE 5)
•Place the drive wheel onto the end of the axle that has an indent. The long end of the hub goes to the inside.
•Place a hub cap onto the end of the axle. Using a small hammer, lightly tap the hub cap until it is snug against the wheel.
HUB CAP
FIGURE 5
STEP 4: (SEE FIGURE 4)
•Place the wheel (long end of hub first) onto the end of the axle that has no indents.
•10. Place a 1/2" flat washer onto the axle and then lightly tap a hub cap onto the axle until it is snug against the washer and wheel hub.
END WITH NO
CROSS HOLE
1/2" FLAT WASHER
HUB CAP
FIGURE 4
STEP 6: (SEE FIGURE 6)
•In order to assemble the hitch bracket to the hitch tube, turn the spreader upright on its wheels. Assemble the bracket to the top of the hitch using two 1/4" x 1" hex bolts and 1/4" nylock nuts.
HITCH PIN
1/4" x 1"
HEX BOLT
1/4" NYLOCK NUT
HAIR COTTER PIN
FIGURE 6
Call | 5 |
DO NOT RETURN TO STORE |
|