STEP 11: (SEE FIGURE 11)

•Assemble the flow control mounting bracket to the hitch tube using two 1/4" x 1-1/2" hex bolts, four 5/16" flat washers and two 1/4" nylock nuts. Do not tighten at this time.

FLOW CONTROL

MOUNTING BRACKET

1/4" x 1-1/2"

HEX BOLT

5/16" FLAT

WASHER

5/16" FLAT

WASHER

1/4" NYLOCK

NUT

FIGURE 11

STEP 13: (SEE FIGURE 13)

•Position the flow control mounting bracket.

•Push on flow control arm until it locks in "OFF" position.

•Slide flow control mounting bracket along tube until closure plate in bottom of hopper just closes.

•Snug the 1/4" lock nuts just enough to hold flow control mounting bracket in place.

•Set adjustable stop at "5". Pull flow control arm against stop.Verify that closure plate has opened about half way.

•If closure plate does not open half way, it may be closed too far at "OFF". Adjust position of flow control mounting bracket until closure plate will open about half way at "5" and still close when arm is locked in "OFF". Tighten 1/4" lock nuts.

ON

OFF

FLOW

 

 

 

 

 

OFF

CONTROL

 

 

 

 

 

 

 

 

 

ARM

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ON

 

 

 

 

 

 

 

 

2

1

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

4

 

 

 

 

 

 

 

5

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

7

 

 

 

 

 

 

 

8

 

 

 

 

 

 

 

9

 

 

 

 

 

 

 

10

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

STEP 12: (SEE FIGURE 12)

•Place the adjustable stop into the "ON" end of the slot in the top of the flow control mounting bracket. Secure with the 1/4" x 3/4" carriage bolt, a nylon washer, a

5/16" flat washer and the nylon wing nut.

WING NUT

5/16" FLAT

WASHER

NYLON

WASHER

1/4" x 3/4"

ADJUSTABLE

CARRIAGE BOLT

STOP

FIGURE 12

AJDUSTABLE

STOP

SETTING "5"

FIGURE 13

•Before operating the spreader, pre-lubricate per the lubrication instructions in the owner's manual.

Call 1-866-576-8388 for missing parts or assembly help

7

DO NOT RETURN TO STORE