Sears 536.25587 owner manual To Start Engine with a Weak, Battery See Fig, To Replace Fuse See Fig

SERVICE AND ADJUSTMENTS

TO START ENGINE WITH A WEAK

BATTERY (See Fig. 38)

CAUTION: Lead-acidbatteries generate explosive gases, Keep sparks, flame and smoking materials away from batteries.

Always wear eye protection when around

batteries°

IIyour battery is too weak to start the engine, it should be recharged. If "jumper cables" are used for emergency starting follow this procedure..

IMPORTANT: YOUR TRACTOR IS EQU1PPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES

TO ATTACH JUMPER CABLES -

•Push battery boot away from POSITIVE (+) terminal.

eConnect RED (+) cable to POSITIVE (+) terminal on battery, taking care not to short against chassis..

•Connect BLACK (-) cable to NEGATIVE (-) terminal on battery.

TO REMOVE CABLES, REVERSE ORDER -

eBLACK (-) cabte from battery

eRED (+)cable from battery.

RUBBER BOOT

NEGATIVE {-)	POSITIVE (*)
TERMINAL	TERMINAL

Fig. 38

TO REPLACE FUSE (See Fig. 39)

•Raise hood.

e Locate fuse holder under dash,

eRemove fuse and replace with a t5 amp automotive- type plug in fuse (see REPAIR PARTS section for more intormation),

TO REPLACE HEADLIGHT BULB

(See Fig. 40)

•Raise hood, NOTE: Do not remove plastic headlight lens when replacing headlight bulb

eTurn headlight harness (holding bulb) !/4 turn counter- clockwise and remove

•Pull bulb out (do not unscrew) Push in new bulb

eReplace headlight harness and turn 1/4 turn clockwise to lock in place..

eClose hood..

INTERLOCKS AND RELAYS

DASH

W1REHARNESS

FUSE HOLDER FUELTANK

FIG. 39

HOOD

HEADLIGHT

LENS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring See electrical wiring diagram in the REPAIR PARTS section of this manual.

BULB HEADUGHT

HARNESS

Fig. 40

31