Sears 580.75133 owner manual Assembly, Carton, Intake Supply, Checklist

ASSEMBLY

Read these instructions and Operator's Manual in its en- tirety before you attempt to assemble or operate your new high pressure washer. Your high pressure washer has, for the most part, been assembled at the factory, except those parts left unassembled_ Before you can operate your new high pressure washer',you must properly connect the high pressure hose.

IF YOU HAVE ANY PROBLEMS WITH THE ASSEMBLY OF YOUR PRESSURE WASHER, PLEASE CALL THE PRESSURE WASHER HELPLINE AT 1-800-222-3136.

TO REMOVE PRESSURE WASHER FROM

CARTON

,,Remove gun and wand assembly from cardboard holder.

oRemove all other packing material from box before removing your high pressure washer.

Refer to Page 5, "Contents of Hardware Pack" for an illustrated listing of all the items included with your pressure washer. Become familiar with each piece before assem-

bling pressure washer. Check all contents against illustra- tions on Page 5 If any parts are missing or damaged, call the Pressure Washer Helpline. at 1-800-222-3136

FIG. 2

HIGH PRESSURE

OUTLET

HOWTO SET UP YOUR PRESSURE WASHER

Included with this unit is a quick-connect fitting that you attach to the water inlet. It can separate into two parts

--a male connector and a female connector that contains an inlet screen. Make sure this screen, as well as the intake supply filter, is clean. Attach the male connector of the quick-connect to the intake supply opening on the front of the pump (Fig 1). The water supply will be attached to the female connector.

INTAKE SUPF

INTAKE SUPPLY

FILTER

FEMALE CONNECTOR

INLET SCREEN

FIG. 1

=Unravel high pressure hose and attach to spray gun (Fig. 2). Tighten with two adjustable wrenches as illus- trated, Do not try to tighten without holding second nut.

oTo attach the high pressure hose to the unit (Fig 3) push the "O"-ring connector of the hose.into the high pressure outlet and then hand tighten until secure.

,,Attach adjustable nozzle extension to spray gun by inserting threaded end of extension into end of spray gun and tightening the extension by hand until it locks in place (Fig. 4).

FIG. 3

FIG. 4

CHECKLIST

,,Check for proper hose connections (high pressure and water supply) and for tight connections and that there are no kinks, cuts, or damage to the high pressure hose_

,,Provide proper water supply (not to exceed 104°F)_

,,Be sure to read "Safety Rules" and "Operation" sec- tions before using the pressure washer,

6