SECTION 5
SERVICE TECH. INFORMATION
II
5A.TROU B LES H OOTI N G
CORRECT SWITCH DISPLAYS
VALVE CYCLE STATUS
Valve in service, fill, brining, back- wash or fast rinse position
Valve rotating from one position to another
°Press the SELECT button and hold 3 seconds un- til...
SR 17 shows. _
JCODEI
This code identifies the softener nominal capacity
C° While in this diagnostic screen, the following in-
formation is available and may be beneficial for
various reasons. This information is retained by
the computer from the first time electrical power
is applied to the face plate.
--Press [_ to display the number of days this
face plate has had electrical power applied.
--Press [_ to display the number of regenera- tions initiated by this face plate since the SR code
number was entered.
size. If the wrong number shows, the softener will
operate on incorrect programming. Do the following as needed.
Return the present time display: Press the SELECT button.
Change the SR number: To display the correct SR number, press the{_UP or DOWN {_ button. Press SELECT, and reset the tim_ _
NOTE:
If the face plate is left in a diagnostic display (or a flashing display when setting times or hardness), present time automatically returns if a button is not pressed within 4 minutes.
FACE PLATE REPLACEMENT: Be sure the valve is
in service | position | (observe | valve cycle | indica- |
tor) when | replacing | the face | plate. | /flO |
If, after installing and programming the replace- ment face plate, the valve is not in service position, do the following to assure correct cycle orientation, or timing, between the face plate and valve.
Use the MANUAL ADVANCE procedures, page 22.
With | the | RECHARGE NOW | button, | advance | ||
through | the | recharge | cycles until | the | valve | stops in |
service | position, and | RECHARGE no | longer flashes | |||
in the | timer. |
|
|
|
| CAM /, |
NOTE: The valve motor may automatically drive through several valve positions while searching for service. If an error code occurs, unplug the trans- former, then plug in again.
21
