Cleaning of Humidifier
CAUTION: To reduce the risk of injury, fire or damage to humidifier,
use only cleaners specifically rec-
ommended for humidifiers. Never
use flammable, combustible or poi- sonous materials to clean your
humidifier. To avoid scalds and
damage to humidifier, never put hot water in humidifier.
CAUTION: Local water purity may vary from area to area and under cer-
tain conditions water impurities and airborne bacteria may promote the
growth of microorganisms in the res- ervoir of a humidifier.
To retard bacteria growth that may cause odors and be harmful to your health, use only Sears replacement filters. We als0 recommend using a
EPA approved bacteriostat,
NOTE: If it is necessary to use approved bacteriostat, fotlow ttle directions cor-
rectly.
The bottle of the whoie house humidifier will hold
Step !
To make cleaning easier, the water resero voir should be empty and completely dried out. To accomplish this. use the fol- lowing method:
a. A_low the humidifier to run until the automatic shutoff turns the humidifier "OFF",
b. Unplug humidifier
WARNING: If humidifier is not
unplugged, fan could start after housing is removed.
c, Follow instructions in step 2 below "To Remove Parts"
d. After removing the parts, dry out the bottom of the humidifier cabinet,
e. Proceedto
Step 2
TO Remove Parts
a, Remove the water bottle cover and the water bottle. Set parts aside
b. Lift and _ernove the fan assembly and set aside.
c. Remove the fitter housing Before removing the internal parts of the flurnidifier cabinet, we recommend moving the humidifier to an area where floor coverings are not susceplib_e to water damage, i.e., kitchen or bath area.
d, Remove the filters and the water _evel float.
e The cabinet should be empty, if any water is in the cabinet, empty as nec-
essary
f, Proceed
"End of Season Maintenance" Con- tinue to clean cabinet and internal pads as described below
Step 3
Install new filters (purchase the co_ec_ evaporative wicking filter pads
the old filters were positioned Replace fit- ter housing Reinstall the water level float into the cabinet, Position the fan assenrbly
on top of the cabinet and replace the water bottle and water bottle cover The
unit is ready for storage or operational
_Jse,
]
1
11