Unit Adjustments
Wall Oven Adjustment
ELECTRIC IGNITION - BAKE BURNER WITH ELECTRIC GLOW BAR
a.The bake burner is equipped with an electric control system as well as an electric oven burner ignitor (figure 2). This control system requires NO adjustment. To operate, turn thermostat knob to any temperature setting or to broil. Current will flow to the ignitor. It will "glow" similar to a light bulb. (This glow may be reflected into the oven through the openings in the oven bottom). When the ignitor has reached a temperature sufficient to ignite gas, the electrically controlled oven valve will open and flame will appear
at the oven burner. There is a time lapse from 30 to 45 seconds after the thermostat is turned ON before
flame appears at the oven burner. When the oven has reached the dial setting, the glowing ignitor will go OFF. The burner flame will go "out" in 20 to 30 seconds after the ignitor goes "OFF". To maintain any given oven temperature this cycle will continue as long as the dial is at the given temperature. Figure 3 is an illustration of a typical range.
GAS SUPPLY PIPING (NOT SUPPLIED BY MANUFACTURER)
MANIFOLD-
PRESSURE
TAP
SER
PLATE
FIGURE 2
b.In case servicing should become necessary, a manual gas valve to shut off the gas to the oven burner is
supplied between the gas regulator and the oven burner valve, tt is located at the front of the oven
bottom or on right rear of gas regulator. See figure 3.
c.The oven CANNOT be used during periods of power outage. In case of power failure, turn the thermostat to the OFF position.
PRESSURE
REGUALTOR
ICAL
DISCONNECT
NUAL OVEN VALVE-
(SHOULD SERVICE EVER BECOME NECESSARY)
WHEN THE INSTALLER HAS COMPLETED INSTALLATION OF APPLIANCE, LEAVE THE APPLIANCE MANUAL
FIGURE 3
