Sears 831.105021 SPA Shell Diagram SPA Operation, Six uni-directional thera-jets, Suction vent

SPA SHELL DIAGRAM

C

A

E

A

B

SPA OPERATION

Refer to the diagram above. The function of each component is explained below:

The	six uni-directional thera-jets	(A) are located on
the sides of the spa. Five jets focus a water massage
on your upper or lower back. The remaining jet pro-
vides a foot hydro-massage when you are in the
reclining seat.
The	three multi-directional thera-jets	(B) can be

adjusted for a custom hydro-massage. One of the jets is located on the reclining seat and focuses the water massage on your lower back. Another jet is located on one of the bench seats, below a uni-directional thera-jet, and focuses a water massage on your lower or middle back. The remaining jet, located on the other bench seat, focuses a water massage on your upper or lower back.

Note: Each thera-jet can be shut off by being pressed in and turned back on by being pulled out.

G

A

B

F

D

A

B

The filter (C) can be removed for cleaning and replacement (see page 17).

The	suction vent	(D), located near the floor of the
spa, brings the water into the pump, in order to oper-
ate the system. The suction cover should always be in
place over the suction vent.			Never operate the spa
without the suction cover in place.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the			ozone jet	(E). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.

The temperature probe (F) reads the current water temperature, which is displayed on the console.

The spa also has a light (G) for evening use.

The spa features automatic freeze protection. If the

water temperature falls below 40°F (4°C), the pump will begin circulating and heating the water to prevent the water from freezing.

11