Sears 831.105021 user manual SET-UP and Assembly, Assembly Requires the Following

SET-UP AND ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

•Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation.

•Assembly requires two people.

•Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

•During assembly, make sure that all parts are ori- ented as shown in the drawings.

•Read each assembly step before you begin.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

ASSEMBLY REQUIRES THE FOLLOWING

TOOLS (not included):

• One (1) phillips screwdriver

1.Before beginning assembly, make sure that you have read and understand the information on

the previous two pages.

Remove the four screws from the access cover		on
the console side of the spa. Remove the access
cover by sliding it down and then pulling		the bottom
of it away from the spa.	Be careful not to damage
the spa shell.

Remove the Power Cord with the GFCI from inside the spa.

2.Locate and check the positions of the two cut-off valves. The cut-off valves may have been closed at the factory during manufacturing. However, the cut- off valves must be open for spa operation. To open the valves, hold the handles and turn them until you

can pull them out to the open position.	IMPORTANT:
THE MOTOR WILL BE DAMAGED IF IT IS OPER-
ATED WITH THE CUT-OFF VALVES CLOSED.

Close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the drain plug into the Pump Motor (13). Tighten the two pump fittings.

1
			Access
			Cover
			Screws
			Power Cord
2
	Cut-off		Cut-off
	Valve
			Valve
			13
			Drain Hose
	Valve	Drain	Pump
Cap		Plug	Fittings
	Knob

8