Sears 831.105021 user manual Choosing a Location for the Hydrotherapy SPA

CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA

There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa.

If you set up the hydrotherapy spa inside:

1.The hydrotherapy spa will increase the level of humidity in your home. The location you choose should be well ventilated. You may need to install a ventilation fan or use a dehumidifier.

2.The hydrotherapy spa should be close to a source of water.

3.Do not use the hydrotherapy spa on carpet or other material that may be damaged by moisture. We recommend that you place the spa on a

water- and stain-resistant, non-slip surface with a floor drain for any water that may splash from the spa.

4.Be sure that the location you choose is stable. It must be able to support the weight of the hydrotherapy spa when it is filled with water plus the weight of the occupants. The hydrotherapy

spa weighs approximately 2,000 pounds (908 kgs) when filled with water.

5.Do not use the hydrotherapy spa above a finished

living area due to the risk of water damage.

6.Be sure that there is room around the hydrothera- py spa to permit servicing of the unit. The dimen-

sions of the spa are: 5’ 10” W x 6’ 4” L x 2’ 6” H (153 cm x 183 cm x 61 cm). Make sure to allow

for this size when choosing the location.

7.The hydrotherapy spa is not designed for in-floor installation. However, it is compatible with a deck system that is built flush with the top of the spa, provided you leave access to the motor for ser- vice.

8.Make sure to consider such factors as aesthetics

or privacy that may affect the safety or enjoyment of using the hydrotherapy spa.

If you set up the hydrotherapy spa outside:

1.You should check your local building codes con- cerning the use of outdoor spas.

2.The hydrotherapy spa should be close to a source of water.

3.We recommend that you place the hydrotherapy spa on a water- and stain-resistant, non-slip sur- face. Do not use the spa on rough or sharp sur- faces such as gravel or wood chips.

4.Be sure that the location you choose is stable. It must be able to support the weight of the hydrotherapy spa when it is filled with water plus the weight of the occupants. The hydrotherapy

spa weighs approximately 2,000 pounds (908 kgs) when filled with water.

5.Think about environmental factors, such as rain,

wind, shade, sunlight, and so forth.

6.You should be able to monitor the use of the hydrotherapy spa from your home, to prevent unauthorized use by children. You may want to enclose the spa with a fence and self-latching gate to prevent unauthorized use.

7.Be sure that there is room around the hydrothera- py spa to permit servicing of the unit. The dimen-

sions of the spa are: 5’ 10” W x 6’ 4” L x 2’ 6” H (153 cm x 183 cm x 61 cm). Make sure to allow

for this size when choosing the location.

8.The hydrotherapy spa is not designed for in-ground installation. However, it is compatible with a deck system that is built flush with the top of the spa, provided you leave access to the motor for service.

9.Make sure to consider such factors as aesthetics

or privacy that may affect the safety or enjoyment of using the hydrotherapy spa.

7