3.Remove the two warning decals (not shown) from the spa shell. Wipe out the spa shell using a damp cloth. Before you fill the spa, make sure that it is in the desired position and that it can easily be ser- viced. Once the spa is filled with water, it must be drained before it can be moved.
Using a garden hose or other clean water source, |
| ||
begin filling the spa. | Do not use soft water. | You | |
may fill the spa with cool water; however, if you use |
| ||
warm or hot water, the spa will be ready to use |
| ||
sooner. Fill the spa until the water is about four |
| ||
inches (10 cm) below the console. | Do not overfill | ||
the spa. |
|
|
|
4. Place the Spa Cover (18) over the spa. |
| Make sure | |
that the Spa Cover is centered. |
|
|
|
Snap a Buckle (2) onto each of the four latches on |
| ||
the Spa Cover (18). |
|
|
|
Pull down one of the straps on the Spa Cover (18) |
| ||
and hold the Buckle (2) against the wood panels on |
| ||
the side of the spa. (Note: To position the Buckle |
| ||
correctly, have a second person hold the strap on |
| ||
the opposite side of the Spa Cover tight.) | The Spa | ||
Cover must be tight. Do not place the Buckle |
| ||
over the grooves between the wood panels. |
| ||
Refer to the inset drawing. Remove the latch from |
| ||
the Buckle (2). Attach the Buckle to the wood panel |
| ||
with two Buckle Screws (1). |
| Note: It may be helpful | |
to use a drill with a 1/16” bit to make starter holes in the wood panel. It may also be helpful to apply a little soap or wax to the screw threads.
Attach the other three Buckles (2) to the wood panels in the same way.
3 |
Fill to Here |
4 |
Strap |
Latch |
Spa |
2 |
1 |
18 |
Spa |
Strap |
2 |
5. Before using the spa, follow the instructions on page 13 to post the included warning sign. | Do not allow the |
spa to be used before the warning sign is posted. |
|
9
