Sears 917.25051 CUSTO RESPON BiLITIES, Cleaning, CLEAN AIR SCREEN See Fig, Muffler, Spark Plugs

CUSTO RESPON BiLITIES

CLEAN AIR SCREEN (See Fig. 16)

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

:_,ENGINE COOLING FiNS (See Fig. 16)

Remove any dust, dirt or oil from engine cooling fins to

prevent engine damage from overheating. Engine blower housing must be removed. Remove side panels and hood (See "TO REMOVE HOOD AND GRILL ASSEMBLY" in the

Service and Adjustments section of this manual).FIG. 17

COOLING FINS

(BOTH SIDES)

AIR SCREEN

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever comes first. Spark ptug type and gap setting are shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual.

\

ENGINE OIL FILTER

FiG. 16

AIR FILTER (See Fig. 17)

Your engine wilt not run properly using a dirty air filter. Clean the foam pre-cleaner element after every 25 hours of operation or every season. Service paper cartridge every 100 hours or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

*Remove wing nut and cover.

=Remove seal and cartridge plate.

TO SERVICE PRE--CLEANER

-Slide foam pre-cleaner off cartridge.

°Wash it in liquid detergent and water.

,Squeeze it dry in a clean cloth.

Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

TQ SERVICE CARTRIDGE

Gently tap the flat side of the paper cartridge to dis- lodge dirt. Do not wash the paper cartridge or use pressurized air, as this will damage the cartridge. Replace a dirty, bent, or damaged cartridge.

-Reinstall the pre-cleaner (cleaned and oiled) over the paper cartridge.

•Reassemble air cleaner, cartridge plate, and seal.

Install the air cleaner cover and wing nut. Tighten wing nut 1/2 turn to 1fullturn after nut contacts cover. Do not overtighten.

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

IN=LfNE FUEL FILTER (See Fig. 18)

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.

With engine cool, remove filter and plug fuel line sections.

Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

=Be sure there are no fuel line Ieaks and clamps are properly positioned.

*immediately wipe up any spilled gasoline.

CLAMP

FUEL FILTER

FIG. 18

CLEANING

,Clean engine, battery, seat, finish, etc. of all foreign matter,

Keep finished surfaces and wheels free of all gasoline, oil, etc.

=Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose to clean your tractor unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine

19can result in a shortened engine life.