Sears 917.25051 manual Se Ce, Ustm Nts, TO REMOVE MOWER See Fig, To Install Mower, with plug

SE CE USTM NTS

with plug.

TO REMOVE MOWER (See Fig. 19)

,,Place attachment clutch in "DISENGAGED" position. = Turn height adjustment knob to lowest setting.

Lower mower to its lowest position.

Remove retainer spring holding anti-swaybar to chas- sis bracket and disengage anti-swaybar from bracket.

-Remove retainer springs from suspension arms at deck and disengage arms from deck.

=Raise attachment lift to its highest position.

•Remove two retainer springs from each front link and remove links.

-Slide mower forward and remove belt from electric clutch pulley.

=Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER

Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the Assembly section of this manual•

ADJUSTMENT
NUTS	LiFT	FRONT
	LINKS	SUSPENSION
SUSPENSION		BRACKET
ARMS
		BRACKET
CHASSIS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPEC tFICATIQNS" on page 3 of this manual). Iftires are over or underinfiated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)

,Raise mower to its highest position.

•Measure height from bottom of deck curl to ground level at front corners of mower. Distance "A" on both sides of mower should be the same.

•If adjustment is necessary, make adjustment on one side of mower only.

-To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each fun turn of adjustment nut will change mower

height about	3/16",
Recheck	measurements after adjusting.
BOTTOM	BOTTOM
OFCURL	OFCURL

FRONT

SUSPENSION

BRACKET

RETAINER

RETAINER

SPRING

ANTI-SWAY

\

NGS

BRACKET

BARRETAINER

SPRINGS

FIG. 19

\

2O