Sears 917.25156 owner manual Ervice and Adjustments, To Remove Mower See Fig, To Install Mower

Models: 917.25156

1 60
Download 60 pages 62.05 Kb
Page 21
Image 21

ERVICE AND ADJUSTMENTS

i± i H,,,m_l_

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

oDepress clutch/brake pedal fully and set parking brake. ° Place motion control lever inneutral (N) position.

° Place attachment clutch in "DISENGAGED" position.

oTurn ignition key "OFF" and remove key.

oMake sure the blades and all moving parts have completely stopped,

°Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with

.............plug......................................................

TRACTOR

TO REMOVE MOWER (See Fig. 18)

°Place attachment clutch in "DISENGAGED" position_

°Turnheight adjustment knob to lowest setting.

°Lower mower to its lowest position.

"sRie _°v_ r_ tai_t_ iSsPn; g ;e°Idinr_gs,anatowaybar t°rChkae_:

o _ee_OaVned _tsaeinn;rgSp_nmgSom dSeUcSkPensionarms at

=Raise attachment lift to its highest position,,

°Remove two retainer springs from each front link and remove links.

=Slide mower forward and remove belt from electric clutch pulley.

°Slide mower out from under right side of tractor,

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE

MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS_

TO INSTALL MOWER

Follow procedure described in "INSTALL MOWER AND

DRIVE BELT" in the Assembly section of this manual

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" on page 3 of this manual). Iftires are over or undednflated, you will not properly adjust your mower,

SIDE-TO-SIDE ADJUSTMENT (See Figs. 18 and 19)

°Raise mower to its highest position.

°Measure height from bottom of deck curl to ground level at front corners of mower,, Distance "A" on both sides of mower should be the same.

°If adjustment is necessary, make adjustment on one side of mower only.

°To raise one side of mower, tighten lift link adjustment nut on that side.

oTo lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each halfturn of adjustment nut will change mower

height about

3/16",,

Recheck

measurements after adjusting.

BOTTOM

BOTTOM

OF CURL

OF CURL

SUSPENSIONADJUSTMENT

FRONT

SUSPENSION

UFT

LINKS

ANTI-SWAYRETAINER

BARSPRINGS

FIG. 18

21

Page 21
Image 21
Sears 917.25156 owner manual Ervice and Adjustments, To Remove Mower See Fig, To Install Mower, To Level Mower Housing