TO LEVEL MOWER HOUSING
Adiust the mower whle tractor is parked on fevet ground or Make sure tires are propedy inflated (See 'PRODUCT SPECIFICATIONS" on page 3 of this manual). If tires are over or undednfiated, you wil not proper_y adi Jst
your mower,
SIDE,.TO_SIDE ADJUSTMENT (See Figs 20 and 21}
oRaise mower to its highest position.
At the midpoint of both sides of mower_ measure height from bottom edge of mower to ground Distance'A'on both sides of mower should be the same or within 1/4" of each other,
•If adjustment is necessary, make adiustrTent on one side of mower oniy.
To raise one side of mower, tighten tiff rink adjustment nut on that side.
oTo lower one side d mower, loosen iift link adjustment nut on that side.
NOTE: Three fut_ turns of adjustment nut wifl change mower height about 1/8'
o Recheck measurements after adjusting
FiG 20
LIFT LINK
ADJUSTMENT NUT
FIG, 21
FRONT
IMPORTANT: DECK MUST BE LEVEL StDE_T'O_SiDE iF
THE FOLLOWING
EQUALLY SO MOWER W_LL STAY LEVEL
SIDE
To obtain the best cutting results, the mower housing should be ad}usted so that the front is approximately I/4," to 3/4' Iower than the rear when the mower is in its highest
Check adjustment on right side of tractor, Measu e dis.- tance "D' directly n front and behind the mandrel at bottom edge of mower housing as shown
oif Inks are not equa_ n length, adiust one tink to same _ength as other link
To tower fn:>nt of mower bosen nut 'E" on both front /inks an equal number of tums_
When distance 'D's 1/4' to 3/4,'lower at front than
rear tighten nuts "F' aga nst trunnion on both fi_ont links.
o"10raise front d mower, loosen nut"F' from trunn on on both front links. T ghten nut 'E on both front links an equal number of turns
oWhen distance D" is 1/4' to 3/4 'lower at front than rear, tig _ten nut _F'_against trunnion or'both front links.
Recheck sideqo.,s de adjustment
FIG, 22
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
NUT "E'
NUT "F"
FRONT LINKS | TRUNNION |
19 | FIG, 23 |
