......................................:.//,ii
AND ADJUSTM
TO REPLACE MOWER BLADE DRIVE BELT | WITHPARKINGBRAKE "ENGAGED" |
|
(See Fig. 25)
The mower blade drive belt may be replaced without toots_
Park the tractor on level surface° Engage parking brake.
BELT REMOVAL -
•Place attachment clutch in "DISENGAGED" position,
°Move attachment lift lever forward to lowermowerto its _owestposition°
•Roll belt off engine pulley_
o Work bett off both mandrel pulleys and idler'pulley.
oPull belt away from mower.
BELT INSTALLATION -
• {nstall new belt in reverse order of removal.
=Make sure belt is inalt pulley grooves and insideall belt guides,
MANDRELIDLER
PULLEYPULLEY
MANDREL
PULLEY
FIG. 25
TO ADJUST BRAKE (See Fig. 26)
Your tractor'is equipped with an adjustable brake system which is mounted on the right side of the transaxle,
If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake mustbe adjusted°
oDepressclutch,'10rakepedaland engage parkingbrake°
•Measure distance between brake operating arm and nut "A" on brake rod.
°If distance is other than
°Engage parking brake and recheck distance.
°Road test tractorfor properstoppingdistanceas stated above., Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear',further maintenance is necessary_. Contact your nearest au- thorized service center_'department_
NUT "A"
AM NUT
TING ARM
FIG. 26
TO REPLACE MOTION DRIVE BELT (See Fig. 27)
Park the tractor on level surface° Engage parking brake,_ For assistance, there is a belt installation guide decal on bottom side of left footrest,
•Remove mower (See 'q'OREMOVE MOWER" in this section of this manuaL)
°Remove upper belt keeper,
°Remove beR from stationary idler and clutching idler_
°Pull belt slack toward rear of tractor, Remove belt
upwards from transaxle pulley by deflecting belt keep-
ers,,
°Pul]belt toward front of tractorand remove downwards from around engine pulley.
°Install new belt by reversing above procedure.,
IMPORTANT; MAKE SURE UPPER BELT KEEPER IS POSITIONED PROPERLY BETWEEN LOCATOR TABS.
|
|
|
| LOCAi'OR |
CLUTCHING |
|
| TABS | |
|
|
| ||
IDLER |
|
|
|
|
|
|
|
| UPPER BELT |
STATIONARY |
|
| KEEPER | |
"*"" |
|
| ||
IDLER |
|
|
|
|
TRANSAXLE |
|
|
|
|
PULLEY | " | "_, | ° | . |
0
FIG, 27
22