Sears 917.257643 ICE and Adjustments, Engine, To Replace Headlight Bulb, Interlocks and Relays

ICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood

°Pull bulb holder out of the hole in the backside of the grill

. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the gdtL

•Close hood

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run pooriy, stop running, or prevent it from starting

•Check wiring See electrical wiring diagram in the Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse The fuse holder is located behind the dash

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 30)

. Raise hood

•Unsnap headlight wire connecter.

•Stand in front of tractor Grasp hood at sides, tilt toward engine and lift off of tractor

-To replace, reverse above procedures

HOOD

HEADLIGHT

WIRE

CONNECTOR

FIG. 30

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

(See Fig. 31)

The throttle controt has been preset at the factory and adjustment should notbe necessary. Checkadjustmentas described below before loosening cable,, If adjustment is

necessary, proceed as follows:

•With engine not running, move throttle control lever from slow (.,l) to choke (t\0 position Slowly move lever from choke (l\l) to fast (._) position

•Check that holes 'W'in governor control lever and hole in governor plate line-up If holes "A" are not aligned, loosen clamp screw and move throttlecable until holes are aligned T_ghten clamp screw securely

GOVERNOR	GOVERNOR
CONTROL LEVER	CONTROL PLATE

HOLES "A"	CLAMP	THROTTLE
	SCREW	CABLE

FIG. 31

24