SERVICE AND
TO REPLACE HEADLIGHT BULB
eRaise hood.
ePull bulb holder out of the hole in the backside of the grill°
QReplace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
°Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.,
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 30)
•Raise hood,
•Unsnap headlight wire connector.
•Stand in front of tractor, Grasp hood at sides, tilttoward engine and lift off of tractor.
•To replace, reverse above procedures.
HOOD
ADJUSTM
ENGINE
TO ADJUST THROTTLE CONTROL CABLE (See Fig. 31)
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
. With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position.
°Check that holes"A" in governor control lever and hole in governor plate
GOVERNOR | GOVERNOR |
CONTROL LEVER | CONTROL PLATE |
\ |
|
HOLES "A" | CLAMP | THROTTLE |
| SCREW | CABLE |
FIG. 31
HEADLIGHT
WIRE
CONNECTOR
FIG. 30
24