To Assemble and Attach Grass, FIG, 3C, FIG, 3A

TO ASSEMBLE AND ATTACH GRASS

,Insert leg of tubular frame through front opening of grass catcher and thread frame into sewn hem of bag,

NOTE: Keep bag hem gathered on the straight leg of the tubular frame,

,u,ii ,111,,11,,i,,, ,,,,i,i,iii1,11

LOWER

FRAME

oWhen frame comes out the other end of sewn hem,

immediately work the end of frame down inside the bag as shown in inset°

oSlide sewn hem evenly around the tubular frame until both ends of frame are exposed out of the front open- ingo

TUBULAR

FRAME

oAssemble lower frame to tubular frame as shown, Be

sure handle is outside of bag and frames are fully seated as shown in inset,

•Slip vinyl bindings over frame,

NOTE: if vinyl bindings are too stiff, hold them in warm water for a few minutes° If bag gets wet, let it dry before using.

•Close the flip lid,, Flip lid must be closed while operating lawn mower.

oLift the rear door on the mower housing and place the grass catcher frame onto the formed tabs on the rear door hinge bracket,,

,The grass catcher is secured to the lawn mower

housing when the rear door is lowered onto the grass catcher frame,,

without clipping deflector or approved

FIG. 3B

LOWER FRAME HANDLE

REAR DOOR

grass catcher in place. Never attempt

AAUTION: Do not run your lawn mower to operate the lawn mower with the rear

door removed or propped open,

HI BRACKET

GRASS

CATCHER

FRAME

TUBULAR FRAME SEWN

HEM

FORMED

TABS

FIG. 4

SEWN HEM

FLIP LID