Sears 93331 Removable Knobs, Removable Cooktop Units, Part, Cleaning Materials, Molded RIB

CLEANING TIPS (cont.)

=

PART

Chrome drip bowls

Brown food stains

Blue/gold heat stains

CLEANING MATERIALS

Detergent and water, plastic scouring pads, mild abrasive cleaners, soap- filled scouring pads, ammonia

Metal Polish

REMARKS]

Bo_Is can permanently disc if !

exp )sed to excessive heat or if soil is allowed to bake on.

After each use, wash, rinse and dr7 to prevent difficult soils. If heavily soiled, place an ammonia-soaked paper towel on stains to loosen sell, then gentl scrub with plastic scouring pad.

These stains are caused by overheating, normally occur over a period of ti_ _, and usually are permanent.

To minimize:

1.	Avoid excessh/e useof the high heatsetting. Use itto startcooking,then lowerthe he	,g]
	to finish cooking.
2.	Use flat bottom pans that do not extend more than two Inches from the surface element.

REMOVABLE KNOBS

The control knobs may be removed for easy cleaning by pulling the knob straight off stem. Be sure that the knob is in the OFF position before removal.

Hint: Slip a thin cloth (such as a handkerchief) or a piece of string under and around the knob edge and pull up.

Caution: Read these instructions carefully be- fore replacing the knobs. Replacing the knobs improperly will damage the knobs and the spring clip on the stems. If this happens, the knobs will fit loosely.

To replace the knob:

1.The knob stem has a groove In each side. The groove on one side has a spring clip. The other groove is clear (see Illustration).

2. Checktheinsideoftheknobandlindthemolded rib.

3.Replace the knob by fitting the molded rib inside the knob into the clear groove on the stem.

MOLDED

RIB

SPRING

CLIP

REMOVABLE

COOKTOP

UNITS

The cooktop elements

can be unplugged and the bowls

IMPORTANT:

Never

operate

a cooktop

element

removed

for cleaning.

without

the

bowl

in place.

This

can

cause

Be sure

all cooktop

unit control knobs

are turned

scorching

of

the

cooktop,

burning of wiring

insu-

off and

elements are cool before

you

remove or

lation

an_f

loss

of energy,

replace

a cooktop

unit.

To remove=

;Grasp element, tilt it upward slightly to clear the bowl, then pull away from the receptacle. The element will not sit level when replaced if it is forced tQo far upward when removed.

2. See the Cleaning

Tips Section about

information or',

\

cleaning reflector

bowls.

REFL _: _l:JR BOWLS

/ /

RECEPTACLE

3. Lift out the bowl.

Do not put the element into water. It cleans itself when

heated during normal use.

1

Replace

the

bowt.

Besurethereceptacleisshowing

Do not lift a plug-in unit more than 1". if you do, it may

in the bowl

opening.

2.

Slide

the

plug

of t he

element

firmly into the receptacle

not lie flat

on the drip pan when you

plug it back in.

Repeated

lifting of the plug-In

unit more than 1" above

and

lower the

element into

place.

the drip pan can permanently

damage

the receptacle. 10

NECCH42