REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when installing or removing oven racks.
To install:
1.Set the raised back edge of the rack on a pair of rack guides.
2.Push the rack In until you reach the bump in the rack guide, then lift the front of the rack and push the rack all the way In.
TO remove:
1, Pull the oven rack out, then up,
Some models have one standard oven rack and one folding oven rack.
The folding rack can be easily stored away when not in use.
NOTE: For best )er_ormance remove oven racks during a clean _ jclc:. If oven racks are left in the range during a s
If you choose t(_ leave the racks in the oven, you can polish the edges of the racks with steel wool and apply a small amount of vegetable oil to the rack edges after the
BUMPiN
RACK_
REMOVABLE OVEN DOOR
To remove:
1.Open the door to the stop position (see illustration).
2.Grasp the door at each side and lift up and off the hinges.
NOTE: When the door is removed and hinge arms are at stop position, do not bump or try to move
the hinge arms. The hinges could snap back causing an injury to the hands or damage to the porcelain on the front of the range. Cover the hinges with toweling or empty towel rolls while working in the oven area.
To replace:
1.Hold the door over the hinges with the slots at the bottom edge of the door lined up with the hinges. The hinge arms must still be in the stop position.
2.Slide the door down onto the hinges as far as It will go and close the door.
STOP (BROIL) POSITION
HINGE
LIFT-UP COOKTOP
The cooktop can be raised so the area underneath can be cleaned.
To raise cooktop:
1.Remove the cooktop units.
2.Grasp the front of the cooktop and lift up until the support rods snap Into position to hold the cooktop.
Porcelain enamel can chip, Handle porcelain enameled cooktops carefully.
To lower cooktop:
1.Push Inonthe front ofthe support rods while towering the cooktop,
NOTE: Some models do not have prop rods.
| J |
| / |
PROP RODS | // |
12 | NEMNT55 |
