![](/images/new-backgrounds/1116405/11640523x1.webp)
OPERATION
USING THE CLEAN=OUT TOOL (See Fig. 14)
in certain snow conditions, the discharge chute may be- come clogged with ice and snow. Use the
When cleaning, repairing, or inspecting, make certain all controls are disengaged and the au= ger/impellerand all moving parts have stopped.
Disconnect the spark plug wire and keep the wire away from the spark plug to prevent ac= cidental starting.
•Release the auger control lever and shut offthe engine.
•Remove the
After the packed snow has been dislodged, return the clean- out tool to it'smounting clip by pushing it into the clip.
•Make sure the discharge chute is pointed in asafe direc- tion (no vehicles, buildings, people, or other objects are in the direction of discharge) before restarting the engine.
•Restart the engine, then squeeze the auger control lever to the handle to clear snow from the auger hous- ing and the discharge chute.
TOOL
FIG. 14
TO MOVE FORWARD AND BACKWARD (See Fig. 15)
the snow thrower, is controlled by the traction drive control lever located on the left side handle.
•Squeeze traction drive control lever to handle to engage the drive system.
•Release traction drive control lever to stop the forward or reverse movement of the snow thrower.
SPEED and DIRECTION are controlled by the drive speed control lever.
Press downward on the speed control lever and move lever to desired position BEFORE engaging the trac-
tion drive control lever. Be sure lever springs back and locks into desired position.
CAUTION: Do not move speed control lever when traction drive control lever is engaged. Damage to the snow thrower can result.
•Slower speeds are for heavier snow and faster speeds are for light snow and transporting the snow thrower. It is recommended that you use a slower speed until you are familiar with the operation of the snow thrower.
NOTE: When both traction drive and auger control levers are engaged, the traction drive control lever will lock the auger control lever in the engaged position. This will allow you to release your right hand from the handle and adjust the discharge chute direction without interrupting the snow throwing process.
TRACTION DRIVE
LEVER
DRaVE SPEED
CONTROLLEVER
FIG. 15
TO ADJUST SKID PLATES (See Fig. 16)
NOTE: The wrench provided in your parts bag may be used to adjust the skid plates.
Skid plates are located on each side of the auger housing and adjust the clearance between the scraper bar and the ground surface. Adjust skid plates evenly to proper height for current surface conditions. For removal of snow in
normal conditions, such as a paved driveway or sidewalk, place skid plates in the highest position (lowest scraper clearance) to give a 1/8" clearance between the scraper
bar and the ground. Use a middle position if the surface to be cleared is uneven.
NOTE: It is not recommended to operate the snow thrower over gravel or rocky surfaces. Objects such as gravel, rocks or other debris, can easily be picked up and thrown by the impeller, which can cause serious personal injury, property damage or damage to the snow thrower.
•If snow thrower must be operated over gravel surface, use extra caution and be sure skid plates are adjusted to lowest (highest scraper clearance) position.
1.Shut off engine and wait for all moving parts to stop.
2.Adjustskid plates by loosening the hex nuts, then mov- ing skid plate to desired position. Be sure both plates are adjusted evenly. Tighten securely.
12