Sears 919.329110 Before Starting Engine, To Start Your Generator, Adding Engine Oil, Gasoline

Connecting Generator To Main Electrical Supply

Potential hazards exist when a electrical generator is connected to the main electrical supply coming into the house. It is at that point that the generator could feed back into the utility company’s system causing possible electrocution of workers who are repairing electrical lines. To avoid back feeding of electricity into utility systems, a double-throw transfer switch should be installed between the generator and utility power. This device should be installed by a licensed electrician and in compliance with all local electrical codes.

NOTE: When installing a Double-Throw Transfer Switch, a minimum of 10 gauge wiring must be used.

BEFORE STARTING ENGINE

Always check engine oil level before every start. Running

engine low of oil or out of oil could result in serious damage to the engine.

Adding Engine Oil

Your generator has been shipped without oil in the engine. Begin by removing the oil dipstick and plug. Start pouring the oil in slowly.

The engine will hold approximately 26 ounces of oil. To check the oil, clean and replace the dipstick. Do not screw the dip stick in when checking the oil level. Next, remove the dipstick to check the level. The oil dipstick is clearly marked with lines that tell you when the engine has enough oil. Do not fill above this point.

•Remove gas cap.

•Add unleaded gasoline, slowly, to fuel tank.

Use clean, fresh, regular unleaded gasoline with a minimum of 85 octane. Do not mix oil with gasoline.

Never fill fuel tank com- pletely. Fill tank to 1/2"

below the bottom of the filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.

•Do not overfill.

Never fill fuel tank indoors. Never fill fuel tank when

engine is running or hot. Do not smoke when filling fuel tank.

To Start Your Generator

Never run engine indoors or in enclosed, poor ventilated areas. Engine exhaust contains carbon monox-

ide, an ordorless and deadly gas.

•Open the fuel shut-off valve. Turn counter clock- wise until the valve stops.

•On the engine there is a ON/OFF switch located on the front panel of the engine. Place this switch to the "ON" position.

NOTE: When adding oil to the engine crankcase, use a high quality detergent oil classified “For Service SF,SG,SH” rated SAE 30 weight. Use no special additives. Select the oil’s viscosity grade according to your expected operating temperatures.

ON

STOP

•Move the choke control located on the engine to "FULL CHOKE" position.

NOTE: No choke is required on warm engines. Make sure choke is in the "NO CHOKE " position on warm engine starts.

Gasoline

Your generator engine is 4 cycle. Use unleaded fuel only. Never mix oil with gasoline.

13 — ENG D20508