Care and Cleaning
Cleaning the Igniters and Other Burner Components
caution
Use care while cleaning the igniters. The porcelain is fragile and can crack or break.
IMPORTANT: The igniters will not work properly if the other burner parts or the igniters themselves are not clean. Dirty or wet igniters may not spark at all.
After disassembling the burners, check for any dirt or grime deposited on the individual parts, including the igniters.
1.Clean completely around the igniter, including over and under the edge of the metal top and porcelain base. A firm toothbrush is ideal for this task. Use care while cleaning because the porce- lain is fragile and can crack or break. Do not use water to clean the igniters. If necessary, use a small amount of rubbing alcohol to help dissolve grime.
Burner Base
Igniter
2.Examine the burner heads. Remove anything stuck in the holes with a straightened paper clip, wire or needle. Be careful not to scratch or damage the ring and head. Do not distort the shape of the burner head holes.
3.Clean all the burner parts, including the burner bases, with window cleaner or rubbing alcohol. Use a cleaning brush with plastic bristles or a firm tooth brush. When done, rinse the parts well with clean water. Dry all the parts thor- oughly before
4.Reassemble the cooktop according to the burner and grate assembly instructions on page 5.
Test the burners after reassembling them. If the flame is uneven, be sure that all the burner parts are properly positioned, then check for any remaining dirt or grime on the burner parts or igniter. If erratic clicking is still present, make sure the igniter is completely dry. If the unit still exhibits problems after drying, call your local Dacor Authorized Service Agent.
Cleaning Stainless Steel Surfaces (stainless steel models only)
caution
Always wipe stainless steel (silver colored) surfaces with the grain. To prevent scratching, do not use abrasive cleaners or scrubbers on stainless steel surfaces.
•Clean stainless steel surfaces with the Dacor Stainless Steel Cleaner included with your cooktop. Use it according to the directions on the package. You may order additional stain- less steel cleaner at www.everythingdacor.com. Order part number A302.
•You may also clean the stainless steel surfaces with a mild solution of detergent and warm water. Rinse and dry with a soft,
Cleaning the Knobs and Trim Rings
1.Disconnect the cooktop power plug from the electrical outlet.
2.Turn the knobs to the off position.
3.Grasp each knob and pull straight up to remove. Do not remove the trim rings, they should be cleaned in place.
4.Wash the knobs with a solution of warm soapy water. Dacor recommends hand dishwashing liquid.
5.Clean the trim rings in place with a solution of warm soapy water on a soft damp rag. Use cau- tion to avoid introduction of moisture into the control panel behind the trim rings.
6.To replace the knobs, align the
7.Connect the cooktop power plug to the electrical outlet.
Cleaning the Optional Griddle
Clean the griddle after each use. Wash it thoroughly in hot soapy water to avoid stains from grease
9