14 |
2 |
Figure 1
27
Figure 2
1928
Figure 3
Operating Instructions
Starting The Machine - Figures 1 & 2
A. Before turning on your vacuum cleaner, make sure that the vacuum handle is in its upright locked position and that you have a firm hold on the handle grip to keep the machine from moving forward.
1.Turn the quick release cable hook (14) to the up position by moving it to the left or right (figure 1).
2.Release the power cord plug from the power cord
and lift the cord off of the upper cord hook (27 - figure 2).
3.With the switch (2) in the “O” (OFF) position (figure 2), plug the polarized power cord into a 120 volt outlet located
near the floor.
Switch Position
O= OFF I = ON
Operating Positions - Figure 3
B. When the machine is switched on with the handle in the upright locked position (see A above), the power head and brush automatically rise from the carpet. To release the machine from the upright locked position, press down on the foot pedal (19) and lower the handle into the normal operat- ing position. The brush will automatically lower.
The handle can be lowered to an intermediate stop position in order to lift up the brush head for maneuvering over rugs, etc. To lower the handle to a horizontal position useful for vacuuming under beds, the foot pedal must be pressed a second time. The intermediate stop position can be closed off by the
!WARNING! The quality, condition, coating, texture, age and manufacturing technique of all floor surfaces vary. Therefore, upright vacuums with rotating brushes, including your SEBO, may damage some floor coverings or surfaces. Some types of
Care must be taken to ensure that the bottom of the machine does not contact the floor. If this happens, damage to the floor could occur. If damage occurs, stop using the vacuum cleaner immediately!
Page 6