Sebo G-SERIES Maintenance, Changing the Dust Bag - Figure, Changing the Micro-HygieneFilter, Page

7

29

30

Figure 9

Dust Bag

Part #5093 AM

Maintenance

Always unplug vacuum from outlet ! before dismantling any part of the

machine!

Changing the Dust Bag - Figure 9

Tochange the dust bag, pull the cover release flap forward (#5 on page 5) and lift the cover (7) from the dust bag housing. The cover release flap must remain in a for- ward “pulled-out” position to change dust bags and lock them into place. Squeeze the clamps on both sides of the dust bag sealing plate (29), slide the plate from the holder (30) and push the cap on to seal the bag. Slide the sealing plate (29) of a new bag into the holder and push it in firmly. Re-insert cover into dust bag housing, push it for- ward, then lock it in place by pushing down the cover release flap. You may find it convenient to store the bag cap inside the dust bag housing below the dust bag.

31

32

Figure 10

Micro-Hygiene

Filter

Part #5036AM

Changing the Micro-Hygiene Filter -

Figure 10

The micro-hygiene filter (31) needs to be changed when it becomes extremely dirty or clogged with dust, or after approximately 20 dust bags have been used. To change the micro-hygiene filter, pull the cover release flap (#5 on page 5) forward and lift the cover (7) from the dust bag housing. Then, slide the filter out at the bottom. To replace, lift the safety lever (32) and slide the new filter in using the tracks as guides.

34

33

35

Figure 11

Exhaust Filter

Part #2846

Changing the Exhaust Filter - Figure 11

After 20 bags have been used, change the exhaust filter (33). Remove the dust bag housing (6) from the power head by pressing the housing release button (8). To remove the exhaust filter, push the catch (34) and remove the filter cover (35) and exhaust filter. Insert the new filter, replace the filter cover then insert the dust bag housing back into the power head.

36

37

38

Figure 12

Brush Roller G1

Part #5010AM

Brush Roller G2

Part #2838AM

Changing the Brush Roller - Figure 12

To change the brush roller (37), push the button (36), remove the side plate (38), turn the brush clockwise a quarter of a turn, and pull the old brush roller out. Slide the new brush roller into the brush housing and turn it until it locks into position. While slightly pushing the but- ton (36), press the side plate (38) back into the locked position.

Page 8