ENFORCER
Alarm Paging
∙When triggered by either the purple (+), green
∙The Page LED will indicate which transmitter is sending the signal (Green, Red, or Orange).
∙The Zone LED will indicate which trigger was triggered.
-Positive trigger (purple wire) will flash green.
-Negative trigger #1 (green wire) will flash red.
-Negative trigger #2 (blue wire) will flash orange.
∙Press the ON/ /OFF button after 30 seconds to stop the indicator.
Receiver Power-On
∙The receiver will beep (or vibrate) once each time the receiver is turned on.
Unattended Indicator
∙The receiver will beep (or vibrate) once every 30 seconds to remind the user that it received a page signal from the transmitter.
∙Press the ON/ /OFF button to stop the indicator.
Low-Battery Indicator
∙The receiver will beep (or vibrate) twice following
∙The receiver will also beep (or vibrate) twice every 60 seconds when the batteries are low.
Viewing the Page Memory
∙Scroll back the page signal memory by pressing the ON/ /OFF button repeatedly.
∙The receiver remembers the last 6 page signals received.
∙Page signals will be shown one by one, beginning with the most recent.
∙The receiver will beep once for an alarm page, but will not beep for a manual page.
∙The receiver will beep three times to indicate that all signals have been viewed, or that no signals are stored.
∙Two consecutive page signals carrying the same information are treated as one.
∙Turning off the receiver will erase all stored signals.
Warning
∙Ensure that an antenna is connected before connecting power to the unit. Failure to do so may damage the transmitter.
∙Do not open the receiver or transmitter cases. All adjustments have been made at the factory. There are no user serviceable parts inside.
∙Holes marked 1, 2, and 3 on the transmitter case are factory set. Do not make any adjustments in these holes.
∙Use only AAA size 1.5V alkaline batteries for the receiver.
7 |