SECO-LARM USA E-37EV manual Table of Contents, Introduction, Parts List Dimensions

ENFORCER E-37EV Alarm Pager System
Table of Contents
Introduction	2
Parts List	2
Dimensions	2
Specifications	3
Installation	3-4
Wiring	4
Connection Diagram	5
Programming	5
Audible and Visual Signals Chart	6
Operation	6-7
Warning	7
Troubleshooting	8
Also available from SECO-LARM	8

Introduction

The E-37EV is a sophisticated paging system consisting of two parts: a transmitter with trigger and timing circuitry, and a matching E-37RV receiver with both vibrating and audible paging functions.

The pager alerts users when a protected building or vehicle is being vandalized or broken into, or when someone presses the manual paging button. The transmitter has a maximum output power of 4 watts as allowed by the FCC.

Mount the E-37EV inside the secure area. The transmitter sends a page signal when triggered. The page signal is received by the small, highly sensitive, lightweight receiver. The receiver beeps or vibrates and colored LEDs indicate the type of trigger event.

The system is easy to install in any type of building or vehicle. The two 1.5V AAA-sized batteries (batteries not included) in the receiver will last approximately one month (5 transmissions/day). The receiver can be programmed to receive page signals from up to 3 separate transmitters and the transmitter can page an unlimited number of receivers.

Parts List	Dimensions
1 x Transmitter
1 x Receiver (model E-37RV)		15/16”	3”	21/8”
1 x Wire harness				(54mm)
			(76mm)
		(33mm)
3 x Mounting screws
		41/8”		5/8”
1 x Radio antenna	31/8”			(16mm)
		(105mm)
adapter cord (18”)	(79mm)
2		SECO-LARM U.S.A., Inc.