ENFORCER Mini Vandal Dome Camera
Overview:
Camera
Set screw
Dome cover
Mounting base
Wiring notch
Female BNC connector
DC plug with terminal block
DC jack
Mounting screw
Important:
Do not cut DC jack or female BNC connector as warranty will be voided.
Before Starting:
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within given temperature and electricity limits.
3.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
4.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals*
5.Do not drop the camera or subject it to strong vibrations.
Note: Many video monitors produce strong electromagnetic fields close to the display CRT, especially when the monitor is turned on or during
Installation:
1. | Run hidden cables from the video source and | 5. | Hold the camera against the wall, ceiling, or |
| 12VDC power supply to the camera. Do not |
| other mounting surface while watching the |
| cut the DC jack or female BNC connector as |
| monitor to find the best mounting location. |
| this will void the warranty. If needed, use the |
| Mark that location with a pencil. |
| included | 6. | Mount the mounting base to the wall using |
| terminal block. |
| the 3 included mounting screws. If |
2. | Test to make sure the voltage is correct. |
| necessary, use the included screw anchors. |
| Use only 12VDC. | 7. | Adjust the camera angle as needed. |
3. | Undo the set screw on the side of the dome | 8. | Test the video signal. |
| cover using the included allen wrench and | 9. | Reattach the dome cover to the camera. |
| remove the dome from the base. | 10. | Use the included allen wrench to tighten the |
4. | If mounting outdoors, apply the rubber seal to |
| set screw, securing the dome to the base. |
| the base as shown on page 2, Applying the | 11. | Do a final test of the video camera and |
| Rubber Seal. |
| monitor. |
|
|
| |
| 3 | ||
