10. ACCELERATOR & BRAKE
Be sure to turn power off before performing work, and avoid touching undesignated places. Failure to do so can result in electric shock and short circuit accidents.
Be careful so as not to damage wirings. Damaged wiring can cause electric shock and short circuit hazards.
When performing work such as parts replacement other than those specified in this manual, be sure to contact the company the product was purchased from and confirm the work procedures and find out any precautions prior to performing the work. Inappropriate parts replacement and/or installing with improper adjustment can cause an overload or the parts to come into contact, resulting in electric shock, short circuit, or fire.
After having performed the adjustment or replacement of the volume, be sure to check the variation of the volume value under INPUT TEST in the test mode.
If Accel and Brake operation is not satisfactory, adjustment of Volume installation position or Volume
replacement is needed. Also, be sure to apply greasing to the gear mesh portion once every 3 months.
10 - 1 REMOVING THE ACCELERATOR AND THE BRAKE
A socket wrench for M6 Hexagon bolts and an extension tool are necessary to remove the accelerator and
the brake, in order to perform maintenance. When removing, be careful not to damage wiring or wiring
connector inside the accelerator and the brake.
1Turn power off.
2Apply the extension tool to the socket wrench. Remove the 4 Hexagon bolts which secure the accelerator and the brake.
3The two wire connectors are connected to the accelerator and the brake. Disconnect the connec- tors, and the accelerator and the brake can be removed. Since this work is performed inside the energized cabinet, be very careful not to touch undesignated parts.
