5. Measurement

4.Setting the shutter angle (L-758CINE only).

It is possible to set the shutter angle by turning the Jog wheel while pressing Mode button and ISO2 button .

Note:

Shutter angle: The angle can be set in the range of 1° to 10° (in 1° steps), 15° - 270° (in 5° steps) as well as, 12° , 17° , 22° , 144° and 172° .

" " is displayed continuously on the LCD display if the shutter angle is set to any value other than 180° .

Press both the Mode button and ISO2 button to confirm the shutter angle since it is not displayed.

Reference:

• This setting is only valid when the shutter speed is set to display cine speed (f/s).

5. Press the Measuring button to take a

 

Measured f stopvalue

 

 

 

measurement. Release the Measuring button to

Set shutter speed

 

complete the measurement. The measured value

 

 

 

(f stop value) will be displayed. While pressing

 

 

 

the measuring button, the meter measures

 

 

 

continuously until it is released.

 

 

 

 

 

 

 

 

 

 

1/10 f stop

Measured f stop on analog display

Reference:

You can select aperture scale or EV scale by holding Mode button and pressing AVE./ EV.

The L-758DR/758D displays the measured aperture value in either full or 1/3 stop increments on the analog scale from f/0.7 to 90, while L-758CINE displays it in either full or 1/3 stop increments on the analog scale from F0.5 to F64.

Readings outside the display range or beyond the measuring range are similar to the previous instruction (see page 16).

-20-

Page 26
Image 26
Sekonic L-758DR manual Measurement. Release the Measuring button to