Using the diversity receiver

Using the diversity receiver

To establish a transmission link, proceed as follows:

1.Switch the diversity receiver on (see next section).

2.Switch a transmitter on (see the instruction manual of the transmitter). The transmission link is established and the receiver’s RF level display “RF” ￿ reacts.

It is vital to observe the notes on frequency selection on page 19.

If you cannot establish a transmission link between transmitter and receiver, read the chapter “Synchronizing a transmitter with the diversity receiver” on page 19.

Switching the diversity receiver on/off

￿Push the two battery compartment catches ￿ and open the battery compartment cover ￿.

￿

￿

￿

￿

￿

To switch the diversity receiver on:

￿Press the ON/OFF button ￿.

The red ON LED ￿ lights up and the standard display “Frequency/ Name” appears on the display panel.

To switch the diversity receiver off:

￿Keep the ON/OFF button ￿ pressed until “OFF” appears on the display panel.

The red ON LED ￿ goes off and the diversity receiver switches off.

When in the operating menu, pressing the ON/OFF button ￿ will cancel your entry (ESC function) and return you to the current standard display.

9