Sennheiser EK 100 Synchronizing a transmitter with the diversity receiver

Synchronizing a transmitter with the diversity receiver

Synchronizing a transmitter with the diversity receiver

When synchronizing a transmitter with a diversity receiver, please observe the following:

￿Only use a transmitter and a diversity receiver from the same frequency range (see the type plates on the transmitter and the diversity receiver).

￿Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

You can also contact your Sennheiser partner who will be pleased to calculate intermodulation-free frequencies for you.

￿Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

Upon delivery, transmitter and diversity receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and diversity receiver, you have to synchronize the channels of the devices:

￿Deactivate the RF signal on all transmitters (see the instruction manual of the transmitter).

This prevents that, during the frequency scan, the channels used by switched-on transmitters are displayed as “used”.

￿With a diversity receiver, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 15).

￿Select a frequency bank and a channel on this diversity receiver (“Current List”, see page 15).

If you want to set up a multi-channel system, select a frequency bank with a sufficient number of unused channels for all planned transmis- sion links.

￿Synchronize a transmitter with the diversity receiver (see page 14). The receiver’s frequency, name and pilot tone setting are transferred to the transmitter.

OR:

￿Manually set the transmitter to the same frequency bank and channel that you set on the receiver.

￿Activate the RF signal on this transmitter. The transmission link is established.

If you want to set up a multi-channel system:

￿Repeat the following 4 steps for each additional transmission link:

–Perform a frequency preset scan with the next diversity receiver.

–Select a channel from the same frequency bank as with the first diversity receiver.

–Synchronize a transmitter with the diversity receiver.

–Activate the RF signal on the transmitter.

Using freely selectable receiving frequencies

You can also freely select the receiving frequencies and store these frequencies in the frequency bank “U”.

It might be that the freely selected frequencies are not intermodulation -free

If you use frequencies from the frequency bank “U”, it might be that the frequencies are not intermodulation-free.

￿Contact your Sennheiser partner who will be pleased to calculate intermodulation-free frequencies for you (see www.sennheiser.com).

￿Set each diversity receiver to the frequency bank “U”.

19