Sennheiser EK 100 Putting the diversity receiver into operation, Inserting the batteries/accupack, Charging the accupack, Mounting the diversity receiver to a camera

Putting the diversity receiver into operation

Inserting the batteries/accupack

For powering the diversity receiver, you can either use two 1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack or the DC 2 power adapter (see “Accessories” on page 23).

Open the battery compartment by pushing the two catches in the direction of the arrows and open the cover .

Insert the two batteries or the accupack as shown above. Please observe correct polarity when inserting the batteries/accupack.

Close the battery compartment by pressing on the center of the cover .

The battery compartment cover locks into place with an audible click.

Charging the accupack

To charge the BA 2015 accupack:

Insert the diversity receiver into the L 2015 charger (see “Accessories” on page 23).

The L 2015 charger can only charge the combination BA 2015 accupack/diversity receiver. Standard batteries (primary cells) or individual rechargeable battery cells cannot be charged.

Mounting the diversity receiver to a camera

Use the supplied CA 2 camera adapter to mount the receiver to a camera’s flash mount.

Determine where on the perforated plate the flash mount adapter will need to be fastened so that the receiver can best be attached to the camera.

At this position, place a square nut under the perforated plate .

Fasten the flash mount adapter to the perforated plate using the square nut .