Sennheiser EK 2000 IEM Using the diversity receiver, Switching the diversity receiver on/off and adjusting the volume

Using the diversity receiver

Using the diversity receiver

To establish a transmission link, proceed as follows:

1.Switch the diversity receiver on (see next section).

2.Switch a transmitter on (see the instruction manual of the trans- mitter).

The transmission link is established and the receiver’s RF level display “RF” ￿ reacts.

It is vital to observe the notes on frequency selection on page 28.

If you cannot establish a transmission link between transmitter and receiver, read the chapter “Synchronizing a transmitter with the diversity receiver” on page 28.

Switching the diversity receiver on/off and adjusting the volume

To switch the diversity receiver on:

￿Turn the volume control ￿ clockwise until it clicks.

The red ON LED ￿ lights up. The “Frequency/Name” standard display appears on the display panel.

￿

￿

To switch the diversity receiver off:

￿Turn the volume control ￿ counterclockwise until it clicks.

The red ON LED ￿ goes off and the diversity receiver switches off.

13