Cleaning and maintaining the EZX 80
Cleaning and maintaining the EZX 80
CAUTION
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause a short circuit and damage the electronics.
Keep all liquids far away from the product.
To clean the headset:
Carefully wipe the product with a dry cloth.
If a problem occurs ...
Problem | Possible cause | Solution | Page |
|
|
|
|
Headset | The rechargeable | Recharge the rechargeable | 10 |
cannot be | battery is flat. | battery. |
|
switched on |
|
|
|
|
|
|
|
No audio | The headset is not | Check if the headset is | 12 |
signal | paired with the | paired. If necessary, pair the |
|
| mobile phone. | headset with the mobile |
|
|
| phone again. |
|
| The volume is | Increase the volume. | 16 |
| adjusted too low. |
|
|
| The headset is | Switch the headset on. | 14 |
| switched off. |
|
|
|
|
|
|
Headset | The pairing does | Check if the your | – |
cannot be | not work. The LED | Bluetooth device |
|
paired | flashes 3 times red. | supports the HF or |
|
|
| HS profile. |
|
|
| Start a search for Bluetooth | – |
|
| devices on your mobile |
|
|
| phone (see the instruction |
|
|
| manual of your mobile |
|
|
| phone). |
|
| The headset is too | During pairing, a maximum |
|
| far away from the | distance of 20 cm must not |
|
| mobile phone. | be exceed. |
|
| The mobile phone | Switch the mobile phone | 14 |
| is switched off. | on. |
|
|
|
|
|
Headset does | The operation of the | Reset the headset to the | 21 |
not react to | headset is faulty. | factory default settings. |
|
any button |
|
|
|
press |
|
|
|
|
|
|
|
If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at www.senncom.com.
