Charging the receivers

Charging the receivers

￿Insert the bodypack receiver/transmitter with the BA 2015 accupack installed into any of the charging compartments 2 until it locks into place with an audible click.

The accupack is being charged. The status LEDs 3 and 8 indicate the charging process.

When an accupack is fully charged, the charging process stops automatically.

Accupacks that are left unused for extended periods of time lose a percentage of their electrical charge. This is independent of whether the bodypack receivers/ transmitters are stored in the charger’s charging compartments or not.

To make sure that you always use fully charged accupacks, we recommend the following steps:

￿Fully charge the accupacks for about 4-5 hours before use. Recharge the accu- packs every 2 months at the latest.

If you store the bodypack receivers/transmitters outside the charger:

￿Insert the bodypack receivers/transmitters into the charger as desribed above.

￿Switch the charger on.

If you store the bodypack receivers/transmitters in the charger’s charging compartments:

￿Switch the charger off and on again.

When the status LED 8 of a charging compartment lights up green, the accupack of the corresponding bodypack receiver/transmitter is fully charged.

When the status LED lights up red, the accupack is being charged.

8 L 1039-10