,--_n_,

 

,

 

'

 

:

 

:2

 

i

~

 

 

:,.3_-

L

I

 

I

L__- -

 

Connection to equipment with built-in phantom power supply

Usingthe microphone

In order to get the most out of this microphone please observe the following instructions:

MKE 4032 P 3'("Rock" version)

. Hold the microphone very dose to the mouth (Iip contact)

. Avoid covering the protective mesh cage with your hand

. If distortion accurs correct the setting at the mixing desk or switch in the pre-attenuation (see also "Adjusting the Microphone Sensitivity")

MKE 4032 P ("Studio" version)

. Speak across the top of the microphone

. Avoid covering the protective mesh cage with your hand

.In the event of wind interference or extreme demands upon pop noise use the supplied windscreen

Adjustingthe Microphone Sensitivity

The microphone can process a maximum sound pressure level of >140 dB without distortion. When this level is reached the signal voltage at the microphone output is approx. 1000 mV. In order to prevent the microphone input stage of the connected equipment from being overloaded the microphone sensitivity can be stepped down in two steps: -10 dB and -20 dB. The sensitivity switch

must be operated either with the included switching tao I or with same other suitable tao I.

Usingthe Roll off Filter

The built-in roll off filter can be switched on and off with the help of

a switch which can be accessed after the grip sleeve has been unscrewed.

]@ofj

The bass roll off caused by the filter can be used in order to com-

pensate the close talking effecl and to suppress impact, handling and wind noise.

14

15