Putting the plug-on transmitter into operation

Putting the plug-on transmitter into operation

Inserting the batteries/accupack

For powering the plug-on transmitter, you can either use two 1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.

￿Slide the battery compartment cover in the direction of the embossed arrow and open the cover .

￿Insert the two batteries or the accupack as shown below. Please observe correct polarity when inserting the batteries/accupack.

￿Close the battery compartment.

The battery compartment cover locks into place with an audible click.

Charging the accupack

￿Remove the BA 2015 accupack (optional accessory).

￿Insert the BA 2015 accupack into the L 2015 charger (accupack and charger are optional accessories):

The L 2015 charger can only charge the BA 2015 accupack. Standard batteries (primary cells) or individual rechargeable battery cells cannot be charged.

Plugging the plug-on transmitter onto a microphone

￿Plug the microphone’s XLR-3M socket onto the transmitter’s XLR-3F socket .





￿Tighten the locking ring  in the direction of the arrow.

The transmitter uses the microphone body as an antenna – therefore microphones with a metal casing should be used for best signal transmission.

7