WASHER

Assembly instructions

PRESSURE

Handle

Alignment Holes

Frame

Assy.

Carriage

Bolt

Nut

Washer

Bolts

Hose/Spray Gun

 

Storage Bracket

 

Nut

 

Studs

OPERATOR’S MANUAL

STEP 1: Attach the handle to the frame of the pressure washer. Note: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the frame supports.

Spray

Gun

Safety

Latch

High Pressure

Hose

STEP 4: Attach the high pressure hose to the spray gun using teflon tape on hose threads.

STEP 2: Insert the carriage bolt through the holes from the outside of the unit and attach a nut from the inside of the machine. Tighten nuts.

Pressure

Nozzle

Wand

Coupler

STEP 5: Pull the spring-loaded collar of the wand coupler back to insert your choice of pressure nozzle.

STEP 3: Attach the spray gun/hose storage handle, and bracket to handle. Tighten nuts.

Pressure

Wand Coupler

Nozzle

 

 

 

 

Wand Collar

STEP 6: Release the coupler collar and push the nozzle until the collar clicks. Pull the nozzle to make sure it is seated properly.

High Pressure Hose

Coupler

Collar

Discharge

Nipple

STEP 7: Connect high pressure hose to pumps discharge nipple. Push coupler collar forward until secure.

Cold

Water

Source

Garden

Hose

STEP 8: Connect garden hose to the cold water source.

Garden

Hose

Pump

Water Inlet

STEP 9: Connect the garden hose to pump water inlet.

Inspect inlets. CAUTION: Do not run the pump with- out water or pump damage will result.

97-707 • BG • REV. 7/06

Page 6
Image 6
Shark BG-2820, BG-2527, BG-3735, BG-3030, BG-3040, BG-3532 owner manual Assembly instructions, Pressure