operating instructions
Engine Oil |
Dipstick |
STEP 1: Check engine oil level. Oil level should be level with the bottom of the oil filler neck. Be sure the machine is level when checking the oil level. (Refer to the engine's operating manual included with machine.) We recommend that the oil be changed after the first 5 hours of use, then once every 50 hours. Note: Improper oil levels will cause low oil sensor to shut off engine. IMPORTANT! Do not run engine with high or low oil levels as this will cause engine damage.
Pump Oil |
Dipstick |
Oil Window |
STEP 2: Remove shipping cap and install oil dipstick. Check pump oil level by using dipstick or observe oil level in oil window (if equipped). Use 30 Wt. non detergent oil.
PRESSURE WASHER OPERATOR’S MANUAL
Gas |
Tank |
STEP 3: Fill gas tank with unleaded gasoline. Do not use leaded gaso- line.
Cold
Water
Source
Garden
Hose
STEP 4: Connect garden hose to the cold water source and turn water on completely. Never use hot water.
STEP 5: Trigger the spray gun to eliminate trapped air then wait for a steady flow of water to emerge from the spray nozzle.
Choke |
Fuel |
Valve |
STEP 6: Rotate the fuel
Choke |
Lever |
Fuel |
Valve |
STEP 7: Move the choke lever to the "Choke" position (on a warm engine, leave the choke lever in the run position). Move the choke lever to the "Closed" position. To restart a warm engine, leave the choke lever in the "Open" position.
