Maintaining Your Vac-Then-Steam™
| Replacement filter sets have |
| been provided with your |
| product. Use one of the |
| replacement filter sets when |
1 | another set is drying. |
Thin Filter |
Thick Filter
2
3
24
English
| 3 |
1 | A replacement |
| filter has been provided |
with your product. Use the replacement filter while the other is drying.
2
CARE OF YOUR DUST CUP FILTERS
1Turn OFF “O” and then unplug the vacuum. Pull out the dust cup. See page 7 for instructions.
Lift the filter frame out from the top of the dust cup. Remove the two filter layers from the filter frame.
2Thoroughly rinse the two filters in lukewarm water. Squeeze out any excess water. Air dry for 24 hours before reusing.
3Insert a dry filter set into the filter frame. The order of the filters impacts your dust cup performance. Make sure the thick filter is on the bottom and the thin filter is on top.
Put the frame with the filter set back into the top of the dust cup.
RECOMMENDED MAINTENANCE SCHEDULE: Using only water, thoroughly rinse filters every 3 months and dry for 24 hours. Replace filter set in the
POST-MOTOR FILTER
1Twist the Shark® logo knob on the
2Use both hands to grip cover on both sides and pull cover toward you.
Gently peel the filter off the inside of the cover. Thoroughly rinse the filter in lukewarm water. Squeeze out any excess water. Air dry for 24 hours before reusing.
3Insert a dry filter into the inside of the cover. Snap cover onto the
Twist the Shark® logo knob clockwise to secure cover.
NOTE: Using only water, thoroughly rinse filter every 3 months and dry for 24 hours. Replace filter in the
DO NOT use a hair dryer or any other forced hot air to dry any of the filters.
NOTE: Any other servicing should be performed by an authorized service representative
ORDERING REPLACEMENT PARTS
Go to www.SharkVacThenSteam.com to find replacement filters, accessories, and microfiber pads.
12 | TOLL FREE: |
MV2010WC_11_IB_ENG_100803.indd
www.SharkVacThenSteam.com | 13 |
04/08/10 9:38 AM