Shark NV350UKMS manual Mode 1 Upright Vac, To Assemble, Place the floor nozzle on a level surface

Mode 1: Upright Vac

To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes.

WARNING: The On/Off switch is on the top of the detachable canister. Always ensure the power is OFF (“O” position) before plugging and unplugging.

		d
Upper	b	a
Cord
Storage
Wrap		e
a
	c

Fig. 7 Fig. 8 Fig. 9 Fig. 10

TO ASSEMBLE:

1Place the floor nozzle on a level surface.

2Align the tube of the floor nozzle with the tube on the detachable canister and lower until you hear the two pieces click into place. (Fig. 7)

When attaching the motorized floor brush, ensure that the latching mechanism is fully locked in place to ensure electrical connection has been made.

NOTE: To change floor nozzles press the red release button (a) on the side of the detachable canister, gently hold the nozzle to the floor with your foot and pull the detachable canister up.

(Fig. 8)

3Attach the end of the extension wand to the tube on the back of the detachable canister until it clicks into place. (Fig. 9)

8 HELP LINE: 0844 873 0728

4Slide the accessory holder (a) positioned opposite the upper cord wrap, over the extension wand. Align the tab with the groove and push down.

(Fig. 9)

5Push the handle (b) onto the top of the extension wand until you hear it click into place. (Fig. 10)

6Insert the end of the stretch hose (c) into the connector on the back of the detachable canister.

(Fig. 10)

7Store the dusting brush (d) and the crevice tool (e) on the mounts of the accessory holder.

(Fig. 10)

NV350UKMS_26_IM_ENG_120906_1.indd 8

12-09-06 2:59 PM