SharkRack Enclosure Installation Guide
Installing the Retractable Tip Guard
Step | Detail |
The Retractable Tip Guard should be used when the cabinet is not secured to the floor and equipment is being slid in and out of the cabinet. This feature is used to prevent the cabinet from tipping over.
1.Insert the legs of the tip guard into the base of the cabinet. Detent the spring latches towards the rear of each leg.
Figure 20
42U X 37DP Shown
2.Check the operation of the Retractable Tip Guard. It should freely cycle through its full range of motion.
Note: Some adjustment of the center section may be required for smooth operation. To adjust loosen the (4) screws at the front of the Tip Guard. Reposition the pieces as required. Tighten the screws.
Note: When in use, remember to fully lower both leveling feet on the retractable stabilizer kit until they are firmly planted on the floor.
Figure 21
42U X 37DP Shown
REV D, ECO2773 | Page 22 of 46 |