SharkRack Enclosure Installation Guide
Adjusting or Replacing the Mounting Rails
Step | Detail |
Adjusting the mounting rails:
The mounting rails are factory set at 29.12 inches apart. However, both the front and rear mounting rails are adjustable to any depth within the cabinet.
1.Loosen the screws securing each mounting rail using a Phillips screwdriver.
2.Adjust the mounting rail to the desired location. Make sure each mounting rail is adjusted parallel and square inside the cabinet.
3.Tighten the screws.
4.Repeat steps for any other rail to be adjusted.
Replacing the mounting rails:
To replace any of the mounting rails you must:
1. Loosen the screws securing the mounting rail.
CAUTION: Remove bottom screws first to help eliminate the possibility of the rail falling on your head.
2.Remove the rail and replace with another style rail available from SharkRack.
3. Secure the mounting rail with the screws that | Figure 24 |
were previously removed. | Section view of 42U X 37DP Cabinet |
REV D, ECO2773 | Page 24 of 46 |