SharkRack Enclosure Installation Guide

Installing a Typical 19 inch EIA Power Strip (cont.)

Step

Detail

2. Secure to the SharkTRAC™ using SharkSNAP™ Brackets

Note: There must be two SharkSNAP™ brackets installed which allows a power strip to clip in-between them.

2a. Install a pair of SharkSNAP™ brackets into the SharkTRAC™. See “Using the SharkTRAC™ and SharkSNAP™ on page 28 for further details.

2b. Approach the SharkSNAP™ brackets with the power strip. Align the pins of the SharkSNAP™ bracket with the screw holes on the strip mounting brackets and push the strip straight onto the bracket. There is a spring that holds the strip into place.

2c. Connect necessary cables.

Figure 33

ID-00210-000

REV D, ECO2773

Page 30 of 46